2000 dodge grand caravan heating and cooling diagram


You are searching repair manual in PDF format about 2000 dodge grand caravan heating and cooling diagram use another keyword for search another post or files



  2000 dodge grand caravan heating and cooling diagram Direct Download speed 5787 Kb/s

  2000 dodge grand caravan heating and cooling diagram Full Version speed 6767 Kb/s




2000-2002 Pontiac Grand Prix Low Engine Coolant Level Indicator Always on (Diagnose Low Coolant Level System

0

Filed Under (Pontiac) by admin on 17-01-2011

download
Subject: Models: Low Engine Coolant Level Indicator Always On (Diagnose Low Coolant Level System Operation/Check Sensor for Oil Contamination) 2000-2002 Buick Century, Regal 2000-2001 Chevrolet Lumina 2000-2002 Chevrolet Impala, Monte Carlo 2000-2002 Pontiac Grand Prix 2000-2002 Oldsmobile Intrigue Condition Some customers may comment that the low engine coolant level indicator is always illuminated. Cause The cause of this condition may be due to engine oil contaminating the coolant. Possible sources of oil contamination are internal engine leaks, improper service procedures, or the addition of some types of anti-leak additives to the cooling system. Once in the coolant, the oil leaves deposits on the level sensor creating an insulating film. This film results in a false activation of the coolant level indicator. Correction Diagnose low coolant level system operation and check the sensor for oil contamination using the procedure listed below. Important: No coolant supplements should be used in GM cooling systems, other than what is approved and recommended by GM. The use of “aftermarket” over-the-counter sealing and cooling supplements may affect the operation of the low coolant level sensor. Discoloration of the coolant recovery bottle is normal and does not necessarily indicate that coolant contamination is present. Flush cooling system only when instructed by this bulletin. 1. Verify that the coolant is at proper level in the radiator and the coolant recovery bottle. If the coolant is low, add proper amount of 50/50 water and DEX-COOL® mixture. If the low coolant light operates properly, diagnose the cooling system for loss of coolant as outlined in SI. DO NOT proceed further with this bulletin. 2. Remove the low coolant level sensor. Refer to Coolant Level Module Replacement in the Engine Cooling sub-section. 3. With the key on, the engine off and the coolant level sensor disconnected from the vehicle wiring harness, observe the low coolant light: • Light is on — Chassis wiring or instrument cluster concern. Follow the appropriate diagnostic information in SI. • Light is out — Proceed to Step 4.

Related entry:

2001 Northstar coolant pressure relief, 2002 grand prix catalytic converter diagram, picture of overflow jug on 2001 malibu and its connection of its hoses, 2000 Chevy Lumina Repair Manual, Northstar Coolant Flow Diagram, idle position sensor 2002 mitsubishi motor 3 0 5 dpd, jetta radiator housing, yhs-synd1ytb, cooler temperature sensor chrysler 300 2000 yotube, how do you bleed the cooling system in a 2005 Neon,

DODGE VAN DODGE CARAVAN/PLYMOUTH VOYAGER 91-95

0

Filed Under (Dodge) by admin on 27-09-2009

REPLACEMENT BODY PANELS Index# Description Year Mill Part# 01 Grille, chrome/black, w/o LE pkg. Caravan 91-95 85-91-01 03Grille, chrome/silver/gray, Voyager 91-95 85-91-03 05 Radiator support panel93-95
85-93-0512 Front bumper cover painted, w/o fog lamps
91-9385-91-12 12 Front bumper cover painted, w/o fog lamps94-95 85-94-12 13 Front bumper reinforcement bar 91-92
85-91-1313Front bumper reinforcement bar

download

Related entry:

cooling system 1997 dodge caravan 3 3 liter schematic, dodge f40, 98 dodge caravan tune up, 73 dodge charger manual, 1986 dodge ramcharger service manual, pics of fuel system relays on 92 dodge b250, 2002 dodge grand caravan sport manual, 69 dodge dart manules, how to remove a right side fender on a 2002 Dodge grand caravan sport, 2005 Dodge Caravan AC Diagram,

2002 Ford Escort Workshop Manual Cooling System Draining Filling and Bleeding

0

Filed Under (Ford) by admin on 07-01-2011

download
Draining 1. Bring the engine to normal operating temperature and turn the engine off. With the cooling system under pressure, inspect cooling system hoses and clamped hose connections for leaks, excessive deterioration or contact wear. Inspect radiator installation retention. Note any discrepancies and proceed. 2. WARNING: Never remove the pressure relief cap while the engine is operating or when the cooling system is hot. Failure to follow these instructions can result in damage to the cooling system or engine or personal injury. To avoid having scalding hot coolant or steam blow out of the degas bottle when removing the pressure relief cap, wait until the engine has cooled, then wrap a thick cloth around the pressure relief cap and turn it slowly. Step back while the pressure is released from the cooling system. When you are sure all the pressure has been released, (still with a cloth) turn and remove the pressure relief cap. CAUTION: The coolant must be recovered in a suitable, clean container for reuse. If the coolant is contaminated, it must be recycled or disposed of correctly and replaced. CAUTION: Some vehicle cooling systems are filled with Motorcraft Premium Engine Coolant VC-4-A (in Oregon VC-5, in Canada CXC-10) or equivalent meeting Ford specification ESE-M97B44-A (green color). Others are filled with Motorcraft Premium Gold Engine Coolant VC-7-A meeting Ford specification WSS-M97B51-A1 (yellow color). Always fill the cooling system with the same coolant that is present in the system. Do not mix coolant types. NOTE: Less than 80 percent of coolant capacity can be removed from the engine. Dirty, rusty or contaminated coolant requires replacement. Drain engine coolant as follows: Open radiator draincock to drain the coolant system. Disconnect radiator overflow hose from radiator filler neck connection. Remove radiator coolant recovery reservoir and empty the fluid. Flush radiator coolant recovery reservoir with clean water. Drain and reinstall radiator coolant recovery reservoir and radiator overflow hose and clamp to radiator filler neck. Correct, repair or install new components found to be inoperative in Step 1. Filling and Bleeding with RADKITPLUS 1. Using the special tool, install the RADKITPLUS and follow the RADKITPLUS manufacturer’s instructions to fill and bleed the cooling system. Filling and Bleeding without RADKITPLUS CAUTION: Engine coolant provides freeze protection, boil protection, cooling efficiency and corrosion protection to the engine and cooling components. In order to obtain these protections, the engine coolant must be maintained at the correct concentration and fluid level in the degas bottle. When adding engine coolant, use a 50/50 mixture of engine coolant and clean, drinkable water. To maintain the integrity of the coolant and the cooling system:

Related entry:

PT Cruiser Cooling System Diagram, 2002 cavalier cooling system diagram, cooling sytem 2002 cavalier, 1999 chrysler sebring convertible radiator fan wiring diagram, 2 2litre cavalier steering cooling system diagram, part diagram for 2001 volkswagen jetta cooling system, 2006 silverado collent skamatic, 2002 cavalier electrical system radiator fan, 04 beetle coolant diagram, Chevy Venture Cooling System Diagram,

2002 Lincoln LS Workshop Manual Cooling System Draining, Filling and Bleeding

0

Filed Under (Lincoln) by admin on 23-01-2011

download
Draining WARNING: Never remove the pressure relief cap while the engine is operating or when the cooling system is hot. Failure to follow these instructions can result in damage to the cooling system or engine or personal injury. To avoid having scalding hot coolant or steam blow out of the degas bottle when removing the pressure relief cap, wait until the engine has cooled, then wrap a thick cloth around the pressure relief cap and turn it slowly. Step back while the pressure is released from the cooling system. When you are sure all the pressure has been released, (still with a cloth) turn and remove the pressure relief cap. CAUTION: The coolant must be recovered in a suitable, clean container for reuse. If the coolant is contaminated it must be recycled or disposed of correctly. CAUTION: Care must be taken to ensure the accessory drive belt does not become contaminated with engine coolant. CAUTION: Some vehicle cooling systems are filled with Motorcraft Premium Engine Coolant VC-4-A (in Oregon VC-5, in Canada CXC-10) or equivalent meeting Ford specifications ESE-M97B44-A (green color). Others are filled with Motorcraft Premium Gold Engine Coolant VC-7-A or equivalent meeting Ford specification WSS-M97B51-A1 (yellow color). Always refill the cooling system with the same coolant that was drained from the system. Do not mix coolant types. 1. Release the pressure in the cooling system by slowly turning the pressure relief cap one half turn counterclockwise. When the pressure is released, remove the pressure relief cap. 2. NOTE: Less than 80% of coolant can be recovered with the engine in the vehicle. Dirty, rusty or contaminated coolant requires replacement. Place a suitable container below the radiator draincock. If equipped, disconnect the coolant return hose at the oil cooler. Close the radiator draincock when finished. Filling and Bleeding With RADKITPLUS 1. Using the special tool, install the RADKITPLUS and follow the RADKITPLUS manufacturer’s instructions to fill and bleed the cooling system. Filling and Bleeding Without RADKITPLUS CAUTION: Engine coolant provides freeze protection, boil protection, cooling efficiency and corrosion protection to the engine and cooling components. In order to obtain these protections, the engine coolant must be maintained at the correct concentration and fluid level in the degas bottle. When adding engine coolant, use a 50/50 mixture of engine coolant and clean, drinkable water. To maintain the integrity of the coolant and the cooling system:

2003-2005 Ford Excursion DIESEL COOLING SYSTEM CONTAMINATION FLUSH PROCEDURE

0

Filed Under (Ford) by admin on 26-01-2011

download
Some 2003-2005 Excursion, 2003-2007 F-Super Duty and 2004-2008 E-Series vehicles equipped with a 6.0L engine may experience engine oil, transmission fluid or diesel fuel contaminating the cooling system. This flushing procedure is to be performed after the source of the cooling system contamination has been identified and repaired. ACTION Follow the Service Procedure steps to correct the condition. SERVICE PROCEDURE Follow the steps in sequence to effectively repair the vehicle: • Drain cooling system contaminates. • Clean cooling system with Simple Green® Heavy Duty Cleaner and Degreaser. • Clean cooling system with Motorcraft® Engine Cooling System Iron Cleaner. NOTE ALL STEPS MUST BE COMPLETED IN ORDER TO PROPERLY CLEAN THE COOLING SYSTEM. ANY DEVIATION FROM THE SERVICE PROCEDURE WILL RESULT IN SHORTENED COOLANT PROTECTION AGAINST CORROSION IN THE COOLING SYSTEM. 1. Determine cooling system condition. Is the contaminated coolant in a flowable, liquid or milky state? a. No – Do not proceed as this procedure does not apply. (Non-Flushable Examples Figures 1-3)

Related entry:

how to flush a radiator coling sistum manual pdf, 2007 beetle 2 5 cooling system diagram, cooling diagram 6 0l chevy, cooling system for 5 4 ford, f 250 5 4 triton cooling system parts, rust in the cooling system of buick rendevous,